Recent content by djn3400

Still not seeing a location in PA

Is there somewhere I could look up these TSB's? I have really abrupt 2-3 shifts under normal acceleration and am curious to see if they mention anything like this.

They are the Lumin8 brand. I got them from Buckle Up Off-Road. The link with videos and instructions are located HERE. I removed the grill to make the install easier and the kit included all of the necessary wiring and connectors to make it plug and play. They tap into the fuse box under the...

Thanks! I hope you like your new bumper as well and were able to get the fogs hooked up.

SOLD

I swapped from the plastic bumper to a capable bumper last month and used the following sensor hole plugs from Amazon - perfect fit. Amazon.com: Masendelk 10pcs Plastic Hole Plugs, Snap in Locking Hole Tube Circular Locking Fastener Cover, Insert End Caps for Furniture Fencing Post Pipe -...

I doubt there would be enough power going to the rears to power 6.5’s. I replaced all of my front speakers but with the stock sized 4” and 6.5”. I fade the EQ to the front only and don’t even use the rears. I’ve found that without amplifying the rears (even just the stock speakers), I can’t hear...

The other option is to just cut them off now, and if you want to go back later (which you probably won't) you could buy the ones with the tow loops and swap them out. It delays, and quite possibly eliminates, the spending on new mounts. Yes, I think you'd have to swap one mount at a time and...

You can use the Key in Bi-Amp mode, which is what I did. This sends lows/mids to the kick panel speakers and mids/highs to the dash if you wire them according to the bi-amp mode wiring diagram in the instructions. I forget the exact frequencies that go to the dash vs. the kick, but it's also in...

Tow rings are not bolted to anything, they are welded to the intercooler brackets. You can buy the intercooler brackets from Ford that do not have them welded and then swap the brackets (these were the OE brackets used on vehicles that came with either the capable or modular steel bumpers).

I can't speak for the aftermarket steel bumpers, but as you can see below, the Ford capable steel bumper can be installed without cutting off the tow rings. I would imagine the same to be true for the capable bumper but I can't say for sure. However, you will have to trim the front edge of the...

BUMP and price lowered to $1,000

BUMP and price lowered to $1,000

BUMP and lowered the price to $1,000

Ordered! Thanks again!