Sponsored
Dannebrog53's latest activity
-
Dannebrog53 replied to the thread 74Weld Portal Review.Thankfully I kept all the takeoff parts and if I have problems in the future they’ll be going back on and my 68 Bronco will be the... -
Good good good. I checked ours and they’re still safely sitting in a pile. Phew!
-
Dannebrog53 replied to the thread 74Weld Portal Review.I definitely have the dowels and everything fit snug, a few “taps” with a dead blow hammer and they were on.
-
74 == Tungsten 55 == Cesium?? I guess there isn't a 100 Falloffium.
-
To be clear, if you have the pins in place I believe the fatigue on the bolts is no longer an issue, assuming they (pins) don’t...
-
I can confirm. I remember talking with SierraBronco through that whole ordeal. I remember exploring all kinds of potential issues. I was...
-
Dannebrog53 replied to the thread 74Weld Portal Review.@zuke you only need to anchor the safety wire if you’re doing a single bolt. With two or more they anchor each other. That being said...
-
I don't have a lot of experience with safety wire, but that looks like it would be a really tricky spot to use it, you need to anchor...
-
Dannebrog53 replied to the thread 74Weld Portal Review.I do have the dowels and thanks @SierraBronco for the info. I’m always learning. We appreciate the time and detailed information you...
-
The problem isn’t that the bolts were loosening due to vibration or “counterfeit loctite” it’s that they were being fatigued every time...
-
Dannebrog53 replied to the thread 74Weld Portal Review.I obviously haven’t done it yet, the photo is just to show that the bolt heads are accessible and can be safetied
-
Dannebrog53 replied to the thread 74Weld Portal Review.I dont know why I didn’t think of it until yesterday but what about safety wiring the mounting bolts once installed? Granted it won’t...
-
-
Dannebrog53 replied to the thread 74Weld Portal Review.I realize it’s a little early to make a determination since the Turn Off-road portals are just now getting into consumers hands and on...
