Recent content by Bubbbba

Cover front only. I am sure this is of little help, but holding up great only on since May and probably 2500 miles

I DIY’d ppf from underground graphics - cut to dies material/ kit is on their website

Thanks!

@Ducati1098 Do you know if I were to have the dealer perform this update. Would it A) Reverse changes l made using forscan? B) Remove the procal tune I have installed? Thanks

Added custom knob made from billiard ball

SAS fender flares for sale. Would ship on you. No dings or scapes. Dayton Ohio $225

Lethal Performance fender flares

See posts 50 and 51 page 4 in this thread for how to

Thanks-would seem by lengthening the pipe with the tip so outlet is at outer edge of bumper would put sound at least somewhat behind the cabin. Please do post thoughts after test drive.

I too am interested in an answer to: What effect would the tip have on the exhaust sound?

I got it o’reily’s like 7 bucks. It is a small gear puller

Replace screw w/longer 5 mm socket head cap screw just a couple turns so it is higher than knob — will pop right off — I damaged my boomba trying to pry with screwdrivers, hammer claws etc

It is metric I think 3 mm

Right, I did not like how the R and C although representative of how they are closer in the pattern, look “squeezed” on to me. Maybe supplier would have made it symmetrical, had I asked?