Recent content by Braptorx

Apologies for the delay. Road manners unchanged if anything smoother especially over speed bumps. Offroad I'm getting no bottoming out now. Is taking a fulload no problem. Still sitting a little higher in the back but I like it. 110km/h dune track run over bumps and a few small whoops and jumps...

Hi Sami, Jacob sent me a message as well. I did the aal gear myself at home and the trmr. I don't notice any additional noise. I use an ecoflow delta 2 and have installed a victron 12 to 36v booster to charge at 400w. Works well. Battery on an AAL slide. Shipping was a lot. Nearly 3k usd air...

Sitting a little high. Haven't driven it yet. But got a 7 hour desert drive tomorrow with a full load. Still need to add fuel, rotopax and the delta max 2 to the load so might level out. Just to add this is rear only. Front is stock.

I was completely blocked anyway by my rear shelf with a packout box on top , hence why I have added a rear view camera mirror, wolf box thing. Anyway I like the look, each to their own....

I went with springs since my load is high. More metal equals more strength in my opinion. Photo just came in with stock on the side and hyperco going on. Significantly thicker

Posting some photos from the shop of the install. All went really easy. Connector for the arb harness extension was too big so hid under seat. We modded an AAL hump panel to house a switch and outlet for the arb. And drilled an extra hole in the AGS kit to bring the air hose back into the...

Just 2 inch heavy duty lift for the rear. I have a 1.5 inch droop already with my aal drawers fridge and battery. Front is fine and I have decided against a winch for the future

Mine is being installed now. Can't wait

Some work in progress on this install. Shows the difference between regular and sequential turn signal really well.

Amazing service from hyperco. Received my springs today in Dubai. 2 days from USA to here. Awesome. Booked install for Monday. Will post before and afters.

Some random light guards from Amazon. Good fit and plastic is well matched.

Hyperco are now in stock ordered mine today. Prompt response and international shipping. Went with 2 inch heavy duty for AAL flip and slide dometic fridge couple of packouts and a delta 2 max battery plus the rotopax on the side, arb, blah bblah blah. Hope it does the job. This squat is unpleasant.

I have the same issue now after 3000km. All raptors hate load I had to put HD +4 on the f150 raptor. Do the arb ones fit? Eibach have a 1.5 inch performance lift that might just do it but no mention on extra weight. Would the fact the lift is there be enough to compensate?

Should have checked first before buying but there was no specific about model on the website has anyone successfully installed the molle on the back of a raptor seat? I can't get the trim to go back in with the bottom bar in place.

Out in the dunes