Recent content by BlarneyStoned

If you want a proper B&O set up, you will need the B&O amp (which uses a different wiring harness than the sub-only amp), A2B wiring, to extend the CAN bus to the amp, plus a harness to tie into the ACM one to run the front speakers. It's more than just the ACM swap to get a working system...

I did that originally but it was so bouncy/shaky I ended up moving it to the cross bar on my Barricade roof rack.

The one I've seen in person I couldn't get too good a look at, but there were definitely zip ties involved.

It's the sub, it hits way harder than the OEM sub, but that's just not good enough. I got the Gearshade/Additivite Audio 3D printed enclosure and put a 10TW3 in it and it is substantially better than the stealthbox AND cheaper. It's still not rattle your neighbors windows loud, for something...

Since I couldn't find any install instructions anywhere I figured I'd add a few lessons learned for the thread: You will need to disassemble the control box for the winch to remove the contactor/solenoid. You will mount the contactor to the winch plate, there are two holes towards the front...

End of August ideally - finally got the Mishimoto intercooler I waited 5 weeks for.

Dirtydog is going/has gone out of business - they've long been out of all Bronco parts.

@DoYouBronco any idea when these will be back in stock?

Thanks that's very useful!

What are the zones you're referencing?

100% recommend this solution, I upgraded from the StealthBox to this and it's a much better sounding option. I also would not bother upsizing the rear-pods, it's just not going to make enough of a difference to justify the extra cost.

For me this will be my backup home internet service that replaced the current 5G fixed wireless I pay for, same $50/mo but unlike the fixed wireless I can take this with me on a trip and it will work in areas without 5G service. Otherwise, yeah I'd probably just pause it when I don't have a...

I almost ordered a refurb one a just after Super Cel too, but hesitated on pulling the trigger cause the next time I'd possibly need it isn't until October and I'm trying to buy a house between now and then, but $299 was too good of a price to pass up. Thanks for taking one for the team 🤣.

Starlink Mini receivers are on sale at retail and directly from Starlink for $299 through 5/28/2025.

mObridge is bridged internally to a single channel, but provides two pairs of output signals but it's mostly to use smaller wires in the harness - you would either combine the + and - wires for an SVC, or you can hook up a pair to a DVC (or combined them and wire the coils in parallel). It can...