Recent content by BisSilent

BRAPTOR installation BADLANDS installation

I have the moroso and I put spring compressors to take a bunch of load off the shocks and still didn't have luck with the moroso. I ended up using a punch that fit in the hole. Sorry if I mislead anyone on the moroso 🤷🏼

This doesn't work very well...the 5/16 punch works much better👍

I removed the plastic behind the wheel liner and cut the rear crash bar brackets...used zip ties to pull the inner fender well back. -25 mm offset Icon Rebound Pros

I've got 315x70rx17 (metric 35") and trying to decide if 37's make since.

What size tires do you have?

I'm guessing 150-160#

Got the coilovers and UCA on. Have a few changes to the coil overs to make to get a little more lift in the front. Before: Non-Squatch Badlands with 1.5" febtech leveling kit After: 2.5 Fox Elite out of the box with Icon tubular UCA Measurements before and after install floor to fender...

Got mine this evening...absolutely no comparison between the two!!!

I have an old Moroso spanner wrench that fits. Looks like they are still available.

Nope, I was planning on using the upper control arms from the kit and decided they weren't what I wanted so I am waiting on a pair of Icon tubular upper control arms to be delivered.

I ended up ordering Icon Tubular upper control arms aren't any better than the stock uca's.

Finally got all the parts👍 Installed one shock before the Boss(wife) came and got me out of the garage🤷🏼 Driver's side rear is on and measured droop with original shock at 28-1/4" from fender to centerline of axle. It increased to 30-1/4" with the FOX.

Thanks for the tracking # advise 👍